Menu
Your Cart

Atmega162 Project Development Board

Atmega162 Project Development Board
Atmega162 Project Development Board
-17 % Pre-Order
Atmega162 Project Development Board
Atmega162 Project Development Board
Atmega162 Project Development Board
  • Stock: Pre-Order
  • Brand: ElementzOnline
  • Model: ATMEGA162-PJT-BRD
  • Weight: 100.00g
  • SKU: ATMEGA162-PJT-BRD
Products Sold: 8
Product Views: 14246
₹499.00
₹599.00

Product Overview

The ATMEGA162/ATMEGA162V Project Board is designed to work with ATMEGA162/ATMEGA162V. The ATmega162 is a low-power CMOS 8-bit microcontroller based on the AVR enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the ATmega162 achieves throughputs approaching 1 MIPS per MHz allowing the system designer to optimize power consumption versus processing speed.

The Project Board is equipped with standard JTAG (IEEE std. 1149.1 Compliant) for Programming & Debugging and 10pin In-System Programming Interface (ISP) Box Header for Programming using any AVR Serial Programmer such as USBasp. And the board by default has 8MHz Crystal.

 

Product Information 

  • Filter capacitor for brownout protection
  • On board 1 Ampere power supply using LM7805 voltage regulator
  • Power supply indicator using On-board LED
  • Input and Output filter capacitors
  • JTAG (IEEE std. 1149.1 Compliant) Interface for Programming and Debugging.
  • ISP with Standard 10-Pin Box Header for programming
  • I/O Expansion headers :-  • 32 Programmable I/O Lines   •  UART expansion (TTL compatible)  • Analog reference header
  • External Oscillator circuitry equipped for connecting Crystal Oscillators
  • Reset switch
  • Board Size: 8.5cm x 7cm
  • Operating Voltage : 5V (7805 on board)
  • Input Voltage : 7V - 35V DC adapter (preferably 12V/9V) 

or You can give 7V-35V DC directly to Vin lines (marked as 12V) on board 

or 5V DC directly to Vcc lines (marked as 5V) on board

(Make sure you connect the GROUND to GND line on board too)

INPUT VOLTAGE (12V/9V), REGULATED VOLTAGE(5V) and GND lines are extended on board itself. So if you need to give power to external sensors/boards, you don't need any external power supply boards

"You can use 12V or 9V DC adapter and connect directly to DC jack on board (input to 7805) but if you are using 5V adapter, remove 7805 from board and short footprints of input (1) & output (3) pins of 7805 using a wire and then connect 5V to the DC power jack"

Package Contents

  • 1 x AVR 40pin ATMEGA162 / ATMEGA162V PROJECT BOARD with JTAG & ISP
  • 1 x ATMEGA162V Microcontroller IC (on board)
  • 1 x 8MHz Crystal Oscillator (on board soldered)
  • 1 x 7805 (on board soldered)
  • 1 x RESET SWITCH (on board soldered)
  • OTHER BASIC COMPONENTS and BERG STRIP EXTENSIONS (on board soldered)
  • 1 x FREE CONTAINER BOX

"If you need a different crystal oscillator on board, you can contact us before making payment. If that particular crystal oscillator is available in stock with us, we can provide you the custom board with that particular crystal oscillator"


Write a review

Please login or register to review
Site uses Cookies
This site uses cookies to provide and improve your experience. By continuing to use this site, you agree to accept these cookies.